Teledyne LeCroy AP033 Differential probe 500 MHz 10:1

Fully integrated: With the ProBus™ interface, the AP033 becomes an integral part of the oscilloscope. The sensitivity and offset of the probe can be controlled via the front panel of the oscilloscope, the front panel of the probe or via remote control commands (GPIB or RS-232). Sensitivity, offset, input capacitance and common mode voltage range are displayed on the oscilloscope screen. No external power supply is required when used with a LeCroy digital oscilloscope.

Wide dynamic range: The AP033 offers a sensitivity range of x10 gain up to ÷10 attenuation (even ÷100 with attachable attenuator) for different signals. The sensitivity can be set continuously from 200 µV/div to 1 V/div when used with a LeCroy oscilloscope.

At high sensitivity, the x10 gain and ÷1 attenuation are selected. This generates 4 NV/√Hz input noise, ±5 V common mode voltage range (CMVR) and ±400 mV differential DC offset. At lower sensitivities, x1 gain and ÷10 attenuation are selected, was ±50 V CMVR and ±4 V differential offset.

The input capacity is only 2 pF/side (1 pF differential) when damping ÷ 10 is selected. Deflection factors of 2 mV/div to 1 V/div can be achieved with only 2 pF/page input capacitance and ±50 V CMVR.

This text is machine translated.