Viessmann Modelltechnik 5280 Switch and point decoder Module
EAN:
Part number:
Item no:
Number
Total (€ 52.09 / piece)
€ 52.09
plus VAT.
Only 9 Piece(s) available
Highlights & Details
Multi-protocol switching and point decoder
Technical specifications
- Product type
Switch and point decoder
- Decoder manufacturer
Viessmann
- Digital format
DCC
MM
- Decoder type
Module
- Selectable effects
Flashing
Dimmer
Randomisation
Signals
- No. of outputs
4 x
- Address range
1 - 1020/2040
- Current at outputs (max.)
5000 mA
- Max. motor current
300 mA
- RailCom support
Yes
- Length
106 mm
- Width
70 mm
- Age category
15 years and over
- Dim
(L x W) 106 mm x 70 mm
- Manufacturer part #
5280
Documents & Downloads
User & Safety Instructions
User & Safety Instructions 1586825 Viessmann Modelltechnik 5280 Switch and point decoder Module
Description
The decoder is a multi-protocol decoder for the DCC and Marklin-Motorola format. It is as soft decoder for 4 points with double coil designed and controls in addition 2 servos. It has 4 output pairs, which is also used for special functions can be configured. So, various light effects can be produced, such as flash for construction site lighting or advertising. To the point outputs recognizes the decoder with the corresponding configuration, the position of the points with end position switch-off and report these position via RailCom.
This text is machine translated.
This text is machine translated.
Features
- 4 pair of points outputs (double coil)
- Outputs can also be configured as a single outputs
- Positive voltage is
- Supply either from the track signal or via external supply for the switching load
- Different functionalities of the Outputs: impulse, continuous, blinking output, dimming, signals, Random control (also in the case of the servo outputs)
- Switching current up to a maximum of 5 A per output
- Decoder total max. 5 A
- With E-socket for power supply of the switching current via a separate transformer
- Maximal total current of the decoder can be set
- LEDs at the outputs indicate the switching command
- Programming on the programming track
- Programming on the main track (POM)
- Address programming also via button
- The servo outputs can be configured for adjusting paths and speeds
- Supply current for both servos total: 300 mA, 450 mA permanently short-term
- With screw terminals.