Adafruit 1413 Accelerometer 1 pc(s)

ADXL377 - High-G Triple-Axis Accelerometer (±200g Analog Out)

The ±200 G 3-axis accelerometer ADXL377 can sense acceleration up to 200 G. The sensor is soldered onto a 0.75" x 0.75" PCB with four 2.5 mm (0.1") mounting holes and a 3.3 V regulator to enable the use with 5 V logic such as an Arduino. Filter capacitors of 0.01 µF enable an output bandwidth of 500 Hz. This board comes with 3 analog outputs for X, Y and Z axis measurements. The 0 G measurement is always at half of the 3.3 V output (1.65 V), -200 G is at 0 V and +200G is at 3.3 V with full scaling in between. Fully assembled and tested, the breakout board comes with an 8 pin 0.1" standard header to use it with a breadboard or a protoboard.