Joy-it ARD-RAMPS-Kit1 Arduino board ARD-RAMPS-Kit1 Compatible with: Arduino
EAN:
Part number:
Item no:
Datasheet (PDF)
Total (€ 32.76 / piece)
€ 32.76
plus VAT.
14-day return policy included
Highlights & Details
Arduino Mega Ramps 1.4 Set including display
- Complete set for installing a 3D printer
- Includes 5 stepper motor end stages (A 4988) and LCD display with rotary knob encoder
Technical specifications
- Connections for up to 5 stepper motors (X, Y, Z, 2 x extruders)
- 3 MOSFET's for the Extuderheizung
- 6 connections for end stop switch or optical end tops
- Connections for up to 3 temperature sensors
- Connection for the HotEnd, Component cooling fan and heater bed
- 5 A fuse for the general circuit
- Separate 11A fuse for heated bed circuit
- Status LEDs
- Includes 5 x A 4988 Motor Driver with heat sink
- Including 128 x 64 Display with rotary knob and cable
- Length
85 mm
- Width
90 mm
- Product type
Arduino board
- Compatible with (details)
Arduino Mega
- No. of digital inputs
3
- Compatible with
Arduino
- Operating voltage
5 V
- Digital inputs
6
- Operating voltage
5 V logic, 12V I/O
- Version
Ramps 1.4
Documents & Downloads
Datasheet
Datasheet 1646890 Joy-it ARD-RAMPS-Kit1 Arduino board ARD-RAMPS-Kit1 Compatible with: Arduino
Description
With this complete set, place the foundation stone for the installation of a 3D printer for Arduino basis.
Not only the required stepper motor amplifiers are with you, but also the board offers connections for up to 3 heating units (bed heating, Extruder 1, extruders 2) with the 3 possible inputs for connection of the required temperature sensors.
In addition, it is also possible to connect fans to the component and extruder cooling.
With the right software installed on the Arduino Mega can be current status messages or information such as temperature on the large LCD display indications are included in the delivery.
This text is machine translated.
Not only the required stepper motor amplifiers are with you, but also the board offers connections for up to 3 heating units (bed heating, Extruder 1, extruders 2) with the 3 possible inputs for connection of the required temperature sensors.
In addition, it is also possible to connect fans to the component and extruder cooling.
With the right software installed on the Arduino Mega can be current status messages or information such as temperature on the large LCD display indications are included in the delivery.
This text is machine translated.
Scope of delivery
- 5 x A 4988 Motor Driver
- Display (including cable)
- Ramps1.4.