Benning MM 6-2 Handheld multimeter Digital LoZ CAT III 1000 V, CAT IV 600 V Display (counts): 6000

The TRUE RMS measuring method and the highest measuring category
CAT IV 600 V allow the device to be used in industrial environments and
ensure reproducible measuring results. The measuring functions meet the manifold requirements of qualified electricians in industry, trade and service. For HVAC technicians, the BENNING MM 6-1 offers a temperature range and
a microampere current range.

TRUE RMS AC/ DC voltage measurement up to 1000 V
TRUE RMS AC/ DC current measurement up to 10 A
Resistance (40 MΩ), frequency (100 kHz) and capacity measurement (10 mF)
Continuity test with buzzer and red LED for loud environments
Diode tests up to a conducting-state voltage of 1.5 V
Volt sensor for non-contact signaling of phase voltages and cable breaks
in lines
Temperature measurement and μA current range (MM 6-1)

“AutoV” function for automatic AC/DC voltage detection and low input impedance LoZ ( 3 kΩ) to suppress reactive voltages
Compact and handy housing design
Protective rubber holster for use in harsh industrial environments
Suspension possibility by means of integrated magnet in the rubber holster
Large LC display with illumination
Memory of measured value (HOLD) and peak value (PMAX, PMIN)
Relative value function (REL) for null balance and differential current measurement
Automatic switch-off after 20 minutes (can be disabled)
Overload protection for all measuring ranges