RAISE3D Left Hotend Assembly Suitable for (3D printer): Raise3D E2 Left Hotend Assembly [S]3.01.1.018.023A01
EAN:
Part number:
Item no:
Number
Total (€ 105.03 / piece)
€ 105.03
plus VAT.
Highlights & Details
RAISE3D E2 Left Hot End Assembly
- Compatible with RAISE3D E2 printerSimple to installAnti-leak and anti-blockage designHeat resistant bis300°C.Nozzle can be replaced (V3 brass nozzle 0.4mm and V3 hardened nozzle)
Technical specifications
- Type
Left Hotend Assembly
- Product type
Hotend
- Suitable for
Raise3D E2
- Nozzle Ø
0.4 mm
- Width
130 mm
- Height
110 mm
- Depth
20 mm
- Suitable for filament Ø
1.75 mm
- Type
Left Hotend
- Printing technology
Fused deposition modeling (FDM)
- Operating voltage
24 V
- Weight
20 g
- UKCA
yes
Documents & Downloads
User & Safety Instructions
User & Safety Instructions 2543942 RAISE3D Left Hotend Assembly Suitable for (3D printer): Raise3D E2 Left Hotend Assembly [S]3.01.1.018.023A01
Description
Replacement hot-end incl. Heating cartridge and temperature sensor (thermistor), suitable for the 3D printer RAISE3D E2, for V3 Brass Nozzle 0.4 mm and V3 Hardened Nozzle. The heater block is marked for the left extruder.Applicability and Compatibility: The RAISE3D E2 Hot End Assembly is compatible with the RAISE3D E2 printer. The thermocouple interface is an easy-to-install terminal that can be plugged directly into the extruder control board.Anti-leak and anti-blockage designThe nozzle of the extruder is seamlessly connected to the neck tube to prevent leaking or clogging of filaments. Heat resistanceThe maximum working temperature is 300°C.Nozzle can be replacedV3 brass nozzle 0.4mm and V3 hardened nozzle
This text is machine translated.
This text is machine translated.
Scope of delivery
- Heater block made of aluminum
- Immersion heater (voltage 24V, power 25-40W)
- 0.4 mm brass nozzle
- 17.7 mm hose
- Thermo element
Hints
Installation tips: When disassembling and reassembling the hot end, turn off the printer. The temperature of the hot end can be very high, therefore please wear the provided heat-insulating gloves and use needle-nose pliers for all procedures. Be sure to check all wiring and power supply values carefully. It is recommended that the nozzle is not tampered with until the power supply has been switched off to avoid the possibility of a short circuit and fire. Please refer to the Hot End Assembly Replacement Guide to learn how to disassemble and assemble the hot end.