TDK-Lambda GEN20-165-1P230 19" bench PSU (adjustable voltage) 0 - 20 0 - 165 A 3.3 kW 1 x RS232 programmable

The 3.3 kW model is only 2HE flat (88 mm height) and can also be stacked directly, and requires no air slot above or below. Output voltages till 20 V and output currents up to 165 A can be set directly on the device or remotely using built-in RS232/RS485. All important functions can get programmed over the analogue inputs (control voltage 0 - 5 V, 0 - 10 V or external resistance, for example, digital control of LabView and LabWindows drivers are appropriate). High-resolution 16-bit A/D and D/A converters enable very precise settings and programming; the dial controls on the device can be switched between coarse and fine adjustment. A dual digital display shows the current values as well as various state information (amongst othersover Voltage Protection, Under Voltage Limit, over load mode, address adjustment ) , and a monitor output provides corresponding analogue voltages (0 - 5 V or 0 - 10 V) for external monitoring The devices can naturally be operated as a constant voltage as well as a constant current source and can, if necessary, automatically switch between these operating modes. Several devices can be switched serially or in parallel. These GEN models are suitable for mounting in 19'' racks. GEN/H models are half the structural shape.