Impulse changeover switch DIN rail Eltako ESW12DX-UC 1 maker 230 V AC, 8 V AC 16 A 2300 W 1 pc(s)

1 N/O contact potential-free 16A/250V AC with tungsten feed-contact, 230V-LED lamps up to 600W, incandescent lamps 3300W. Max. Inrush current 500A/2ms. No standby loss. DIN-EN 60715 TH35 DIN rail mounting device. 1 division unit = 18 mm wide, 58 mm deep. Most modern hybrid technology combines the advantages of wear-free electronic control with the high output of special relays. With the patented Eltako-Duplex-Technology (DX) the normally potential-free contacts during switching of 230V-alternating voltage 50Hz can nevertheless switch in the zero crossing and thus the wear and tear can be drastically reduced. Simply connect the N conductor to terminal (N) and L to 1 (L). This results in a standby loss of only 0.1 watts. Universal control voltage 8..230V UC. Low switching noise. No continuous power supply is required, so no loss in standby mode. The use of a bi-stable relay means that even when switched on, there is no coil power loss and no heat up through it. The relay contact can be open or closed upon commissioning and is synchronized upon first operation. The electronics have no power supply and therefore no power consumption in either contact position. Only during the short control impulse of only 0.2 seconds the control current, which activates the microcontroller, flows. It reads the last switching state from its non-volatile memory, switches the bistable relay accordingly in the opposite direction and writes back the new switching state in the memory.

This text is machine translated.