Lian Li UNI FAN TL LCD Series, 3er Pack + Controller PC fan White (W x H x D) 124 x 120 x 28 mm incl. LED lighting, incl

Lian Li UNI FAN TL LCD Series PWM fans to complement your setup
The Lian Li UNI FAN TL LCD series are fans, which fit perfectly in your setup. The PWM fan is installed on the same plug system that frees the gaming PCs from unnecessary cable mess. Lian Li impresses with regards to cooling performance and delivers new standards with breath-taking RGB lighting.

Personalise your fans via LCD
On the hub of the Lian Li UNI FAN TL LCD series a 1.6-inch display with a resolution of 400 x 400 pixels is mounted, which can be configured almost freely. These can display fan speed, temperature, CPU and GPU load, for example. Or you can upload your own pictures, GIFs or small videos via L-Connect 3 software, in order to give the fans your own personal touch. Lian Li points out that the more sensors are used, the more the CPU is required and therefore no more than three sensors should be used.

Connection system for seamless fan clusters
The installation of the Lian Li UNI FAN TL LCD series follows the clever concept of the other fans from Lian Li: The fans are fitted with contact points and are connected with each other by means of a practical plug-in system. Several fans can be connected together into a cluster and conveniently connected to the controller with just one cable. This improved Daisy chain system saves you time, nerves and eliminates tangled cables. The pin contacts forward current as well as PWM and ARGB signals.

Revised plug system of the Lian Li UNI FAN TL LCD series
The plug system introduced with the UNI FAN SL and AL series has been further improved with the Lian Li UNI FAN TL LCD series. Firstly, the connector system has been designed in such a way that the connector plug can be removed. This prevents possible collisions with connections at the radiator and ensures a clean look at the same time

In addition, the cable module connector has been removed and the cable can now be connected directly to the fan instead. The connection is recessed into the frame flat, so there is more space available for use of radiators.

The commonly separated power and ARGB signal cables have been combined into a 7-pin cable. You can connect these cables directly to the controller. Up to four fans in a cluster can be supplied with one cable. With the appropriate extension cable you can connect up to 6 fans with LCD at both the ports of the controller and control them via L-Connect 3 software.

Note: The connections of the Lian Li UNI FAN TL LCD series are not compatible with the SL and AL series!

Lian Li UNI FAN TL LCD Series: Impressive performance values
The fan is relatively quiet under full load with a maximum of 27 dB(A). The low distance between the fan blades and the frame and the thus reduced friction permits higher speeds with the same power consumption and thus linked a significantly increased air throughput and excellent performance values. Cool temperatures are also favored by the increased height of 28 millimeters.

With L-Connect 3 software you can also activate the start/stop mode for your Lian Li UNI FAN TL Series. If your components are below a temperature you specify (maximum 50 degrees), the fans will remain off. In addition, it is possible to create an optimized fan curve for speed and temperature via L-Connect 3.

Optimised concept for lighting and look
Lian Li has considerably improved the fans. For example, the side LED tape lights with a distance of 0.7 millimeters as compared to 3 and 5.6 millimeters in the previous generation show a clearly reduced distance between the individual fans. This creates seamless transitions between the illuminated areas and fan clusters of cross-effects are amplified. Lian Li has revised the rubber pad design and added additional slots. The unusual RGB light, which also illuminates the infinity mirror on two sides, is thereby more noticeable.

This text is machine translated.